BRP Johnson J30TEL4SUA 2007 Service Manual page 63

Oil Filter Replacement
Remove the engine port side cover. Refer to
ENGINE SIDE COVERS on p. 54.
Use an oil filter wrench to loosen the oil filter.
1
1. Oil filter wrench
Apply oil to the O-ring of the new oil filter.
Screw the new filter on by hand until the O-ring
contacts the filter mounting surface. Then use an
oil filter wrench to tighten the filter by another 3/4
of a turn, or approximately 124 in. lbs. (14 N·m).
1
1. O-ring
Install the engine port side cover.
Filling
Install a new gasket and the engine oil drain plug.
Tighten the drain plug to a torque of 115 in. lbs.
(13 N·m).
1. Oil drain plug
001313
Pour the correct amount of the recommended
engine oil into the oil filler opening, then install the
oil filler cap.
Engine Oil Capacities
Oil change only
Oil and filter change
001314
1. Oil filler cap
Start and run the engine for several minutes at idle
speed.
Check the oil filter for leakage.
Turn off the engine and wait for approximately two
minutes, then check the engine oil level. Refer to
Checking the Engine Oil Level on p. 60.
MAINTENANCE
ENGINE OIL AND FILTER
001316
3.2 qt. (3.0 l)
3.4 qt. (3.2 l)
001311
1
3
1
61