Control Cable Identification - BRP Johnson J30TEL4SUA 2007 Service Manual

INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
Remove grommet from front panel.
1
1. Grommet
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal. Push connectors together until latched.
1. Seal
Insert MWS cable through front panel. Join MWS
harness connectors to engine connectors. Secure
6-pin connectors in clips and push excess trim
and tilt cable underneath air silencer.
1
1. 6-pin connector
40

Control Cable Identification

IMPORTANT:
identified before rigging outboard.
Identify each control cable:
•
Put the control handle into NEUTRAL position.
The throttle cable casing guide will retract com-
pletely and the shift cable casing guide will go to
the midpoint of its travel.
001668
1. Shift cable casing guide extended to midpoint
2. Throttle cable casing guide retracted
Extend the control cables and lubricate them with
Triple-Guard grease.
1
42079A
To prevent accidental starting, disconnect
the battery cables at the battery. Twist and
remove all spark plug leads.
002856
Control cable function must be
WARNING
1
2
DP0811
30501