IMPORTANT:
Use a marine sealant rated for
above or below waterline use. RTV silicone is not
approved for below waterline use. Polyurethane
sealants are not easily removed and may damage
outboard or boat mounting surfaces when
removed.
Apply marine sealer (rated for above and below
waterline use) under hex heads of bolts, on the
mounting plates, and to the bolt shanks.
Tighten bolts to 14.5 ft. lbs. (20 N·m).
2
3
TYPICAL
1. Clamp screws
2. Transom plate
3. Stern bracket holes
IMPORTANT:
After 30 minutes of operation,
retighten clamp screws by hand. DO NOT use
tools to tighten clamp screws. Check clamp
screws regularly.
INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
To prevent accidental starting of engine,
confirm the battery cables are discon-
nected at battery and spark plug leads are
disconnected from spark plugs.
MWS Harness Installation
Remove six (6) screws and starboard side lower
1
engine cover.
DR5815
Port side
Starboard side
OUTBOARD RIGGING
WARNING
2
001722
001723
39