Lifting The Outboard; Steering Systems - BRP Johnson J30TEL4SUA 2007 Service Manual

Lifting the Outboard

Lift the outboard using the lift grips (NOT the tilt
grip or steering handle) and place it in the center
of the boat's transom.
1
TYPICAL
1. Lift grips
Before Mounting Outboard to Transom
Some rigging components that attach directly to
the outboard should be assembled before the out-
board is mounted to the boat's transom. Steering
system components and gearcase speedometer
pickup hoses are the most common. Determine
what equipment will be installed prior to mounting
the outboard to the transom or bracket.

Steering Systems

Mechanical Cables
All Evinrude/Johnson outboards equipped with tilt
tubes are designed to be compatible with
mechanical steering systems that meet ABYC
Standard P-17. Single-cable mechanical steering
systems can be used on single or dual-outboard
installations if an ABYC-approved steering link is
used.
Dual-cable mechanical steering helps provide firm
steering control at high speeds.
INSTALLATION AND PREDELIVERY
Extend the output end of the steering cable and
lubricate the inner core of cable prior to installa-
tion.
1
ABYC-approved mechanical steering cable.
IMPORTANT:
DR4661
tube before mounting outboard on transom.
Tighten nut securely.
Apply Triple-Guard grease to cable and install
cable wiper nut on tilt tube.
1. Cable nut
2. Grease
3. Wiper nut
OUTBOARD INSTALLATION
Install steering cable through tilt
2
5873
004823
37