INSTALLATION AND PREDELIVERY
OUTBOARD INSTALLATION
Drilling and Hardware Diagram
0.53 in
(13 mm)
TYPICAL - Stern bracket for your engine may appear different, but dimensions apply to all 30 to 140 Models.
•
Drill the upper holes at least 1.75 in. (45 mm) away from the transom top surface.
•
Install the large diameter washer (P/N 5030436) on the transom board side.
•
To ensure a water-tight outboard installation, polysulfide sealant should be applied to all bolt holes.
•
If tightening torque cannot be reached to the specified torque due to weak transom material, it is nec-
essary to reinforce the transom board with an attachment plate.
36
Transom top surface
12.9 in. (327 mm)
12.9 in. (327 mm)
12.9 in. (327 mm)
9.9 in. (251 mm)
Item
Part name
1
Bolt
4 in. (100 mm)
4.5 in. (115 mm)
6 in. (150 mm)
2
Washer (large)
3
Washer (small)
4
Lock washer
5
Nut
6
Cap
1
2
sealant
Part Number
Quantity
5030385
4
5030386
4
5033511
4
5030436
4
5030438
4
5030462
4
5030418
4
5030839
4
3
4
5
6