BRP Johnson J30TEL4SUA 2007 Service Manual page 33

Installation Guidelines
Install the appropriate remote control following all
instructions provided with the remote control.
Make sure the following items are checked:
•
Correct length control cables and wiring har-
nesses
•
Proper type and quality of cables and wiring
harnesses
•
Correct routing of cables and harnesses
•
Appropriate slack in front of the outboard for
remote control cables
•
Proper routing of cables to prevent kinking
•
Positioning and securing of cables and har-
nesses along their lengths to prevent movement
or damage
Typical transom-mounted outboard installations
require a 12 in. (30 cm) cable loop at the front of
the outboard when the cables are routed from the
side of the splash well.
1
1. Surface side-mount remote control
2. Cable support
3. 12 in. (30 cm) cable loop at front of outboard
2 3
DR4277
INSTALLATION AND PREDELIVERY
SystemCheck™ Monitor
The SystemCheck engine monitor alerts the oper-
ator of certain engine problems. Refer to the
Operator's Guide for detailed information related
to the various warning signals.
IMPORTANT:
Outboards with remote controls
must be equipped with a SystemCheck (or equiv-
alent) engine monitor. Operating the outboard
without an engine monitor will void the warranty
for failures related to monitored functions.
SystemCheck gauges are available in two sizes.
Typical SystemCheck gauge
Typical SystemCheck gauge with tachometer
BOAT RIGGING
2
DR5206
DR5364
31