Boat Rigging; Remote Controls - BRP Johnson J30TEL4SUA 2007 Service Manual

INSTALLATION AND PREDELIVERY

BOAT RIGGING

BOAT RIGGING

Remote Controls

Control Selection
WARNING
The remote control used must have start-
in-gear prevention. This feature can pre-
vent injuries resulting from unexpected
boat movement when the outboard starts.
Remote control styles and applications are
described in the Evinrude/Johnson Genuine Parts
and Accessories Catalog. Plan the installation of
all remote controls carefully. Read the outboard's
Operator's Guide and the remote control's installa-
tion instructions prior to installation.
The remote control and wiring harness used must
have the following features:
•
Start-in-gear prevention
•
Emergency stop / key switch
•
Shift stroke must measure 1.125 to 1.330 in.
(28.6 to 33.8 mm) between NEUTRAL and
FORWARD
•
Throttle stroke must PUSH for open
30
•
All wiring must be compatible with Modular Wir-
ing System (MWS) components
3
1. Emergency stop clip
2. Safety lanyard
3. Key switch with emergency stop feature
Additional remote control information:
•
Power trim/tilt switch(s) can be integral to the
remote control for outboards with power tilt and
trim.
•
Side-mount controls require a neutral lock fea-
ture.
•
Single-outboard binnacle remote controls are
offered with or without an integrated key switch.
WARNING
Always install and recommend use of an
emergency stop/key switch. Doing so will
reduce the risk of personal injury or death
should the operator fall away from the con-
trols or out of the boat.
002817