Assembly; Installation - BRP Johnson J30TEL4SUA 2007 Service Manual

Assembly

Install the O-ring on the brush holder. Make sure
that the O-ring is positioned correctly
Carefully slide the armature onto the brush holder
to avoid breaking any of the brushes.
1
2
1. Armature
2. Brush holder
3. O-ring
Install the motor case over the brush holder. Make
sure that the alignment marks on the case and the
holder are aligned.
Install and tighten two (2) screws that secure the
motor case to the brush holder.
1
2
1. Motor case
2. Screws (2)

Installation

Make sure that the drive joint is aligned and firmly
inserted into the gear pump assembly.
Check the level of PTT oil in the pump. If the level
is low, add the recommended PTT oil until the oil
is level with the mating surface of the PTT motor.
3
001929
1. Drive joint
Make sure the mating surfaces of the PTT motor
and the reservoir are free of dirt or debris.
Install the O-ring on the bottom of the PTT motor.
Install the PTT motor on the pump. Make sure that
the tip of armature shaft fits firmly into the drive
joint.
2
3
001922
1. Drive joint
2. Armature shaft
3. O-ring
POWER TRIM AND TILT
PTT MOTOR
001931
001932
235
1
2
10
1