POWER TRIM AND TILT
PTT MOTOR
PTT MOTOR
Removal
WARNING
To avoid personal injury, wear eye protec-
tion and set compressed air pressure to
less than 25 psi (172 kPa).
IMPORTANT:
Before removing the motor from
the PTT unit, wash the outside of the unit with a
stiff bristle brush and hot, soapy water to remove
sand or dirt. Dry the unit with compressed air.
First, remove the PTT unit from the engine. Refer
to "POWER TRIM AND TILT (PTT) UNIT" on
page 229.
Unscrew the reservoir plug and drain the PTT
motor oil into a suitable container.
1
1. Reservoir plug
CAUTION
To prevent damage to the PTT unit, use
wood blocks or vise jaw protectors
between the vise jaws and PTT unit before
tightening the vise.
232
Place the lower mounting eye of the PTT unit in a
vise. Tighten the vise only enough to secure the
PTT unit. DO NOT overtighten the vise.
1. PTT unit
2. Vise
Remove two (2) screws and the reservoir.
1
1. Screws (2)
2. Reservoir
Remove the PTT motor from the pump.
001918
Note the positions of the drive joint and the O-ring,
then remove the components.
IMPORTANT:
nents on a rag. Dirt or lint may be transferred to
DO NOT lay out the PTT compo-
1
2
001919
2
001920