BRP Johnson J30TEL4SUA 2007 Service Manual page 233

Position the PTT unit between the stern brackets.
Install and tighten the tilt tube nut to a torque of 31
ft. lbs. (43 N·m).
2
1
1. Stern bracket
2. Tilt tube nut
Apply Nut Lock to the threads of the tilt cylinder
shaft bolts. Install and tighten the bolts to a torque
of 16.5 ft. lbs. (23 N·m).
1. Tilt cylinder shaft bolts (2)
Apply Triple-Guard grease to the tilt rod upper
bushings, then install the bushings in the end of
the tilt cylinder rod.
POWER TRIM AND TILT (PTT) UNIT
Operate the PTT motor to extend the tilt cylinder
rod. Align the tilt cylinder rod with the hole in the
swivel bracket as the tilt rod extends.
001759 1. Bushings (2)
When removing or installing any type of
retaining rings, wear eye protection to
avoid personal injury.
Apply Triple-Guard grease to the tilt rod upper
1
shaft, then insert the shaft through the swivel
bracket and the tilt cylinder rod.
Secure the tilt rod upper shaft with the E-ring.
001935
1. Tilt cylinder upper shaft
Route the PTT motor cable through the lower
cover. Refer to the WIRE AND HOSE ROUTING
section. Connect the lead wires to the PTT relay.
POWER TRIM AND TILT
WARNING
1
001936
1
10
001750
231