Service Procedures; Checking The Oil Level; Bleeding The Air - BRP Johnson J30TEL4SUA 2007 Service Manual

POWER TRIM AND TILT

SERVICE PROCEDURES

SERVICE PROCEDURES

Checking the Oil Level

Raise the engine to the full tilt position.
Lower the manual tilt lock levers.
1. Manual tilt lock lever (2)
Remove the reservoir plug and the oil level plug.
If oil can be seen at level plug hole, the reservoir
is full. If the oil level is low, fill the reservoir with
Dexron III automatic transmission fluid or an
equivalent.
IMPORTANT:
To ensure consistent pump oper-
ation, DO NOT mix different types of oil.
Install oil level plug and reservoir plug.
1. Reservoir plug
2. Oil level plug
228

Bleeding the Air

Check that the manual release valve is tightened
to a torque of 16 in. lbs. (1.8 N·m). Turn the valve
clockwise to close the valve. DO NOT overtighten
the valve.
1
1. Manual release valve
001749
Raise the manual tilt lock levers. Operate the PTT
switch to raise and lower the motor four or five
times from the full tilt position to the full trim down
position.
1
2
Check the oil level. Top off the oil in the reservoir,
if necessary. Refer to "Checking the Oil Level" on
page 228.
001911
1
001912
001913