Driveshaft Assembly - BRP Johnson J30TEL4SUA 2007 Service Manual

GEARCASE
ASSEMBLY
rod cam (with detent notch) is positioned over the
detent ball in the gearcase.
1
1. Shift rod
2. Shift rod cam - stepped section
3. Detent ball
Secure the stop to the gearcase with two (2)
screws.
1
1. Screws (2)

Driveshaft Assembly

Install the thrust washer and the preload spring on
the driveshaft. Make sure that the end of the
spring fits into the notch on the thrust washer.
1. Preload spring
2. Thrust washer
216
Place the tab lock washer and the other thrust
washer in the preload spring collar. Make sure
that the tab of the lock washer fits into the slot at
the pinion gear end of the spring collar.
3
Slide the preload spring collar onto the driveshaft.
2
001873
1
2
1. Tab lock washer
2. Thrust washer
3. Slot
When removing or installing any type of
retaining rings, wear eye protection to
avoid personal injury.
Install the driveshaft and the preload spring collar
in the bearing housing. Firmly push down the col-
lar and secure the collar to the housing with the
001838
retaining ring.
2
1
1
2
1. Retaining ring
2. Preload spring collar
001874
WARNING
3
001878
001879