BRP Johnson J30TEL4SUA 2007 Service Manual page 215

Propeller Shaft Bearing
Housing Seals
Apply Triple-Guard grease to the inner circumfer-
ence of the housing.
Place the new seals in position (one at a time)
with the lips facing toward the propeller. Use oil
seal installation tool, P/N 326545, to seat seals
into bearing housing. Apply Triple-Guard grease
to the seal lips after installation.
Install a new O-ring on the housing.
1
1. O-ring
Reverse Gear Bearing
Apply HPF XR gearcase lubricant to the bearings.
BEARING AND SEAL INSTALLATION
Using suitable bearing installation tool obtained
locally, press the bearing against outer race until
fully seated in the housing.
1
1. Reverse Gear bearing
2. Propeller shaft bearing housing o-ring
001859
Pinion Gear Bearing
To install pinion bearing, assemble tools from Uni-
versal Pinion Bearing Removal and Installation
Kit, P/N 391257, bearing removal/installation kit,
P/N 5000009, bearing removal/installation tool,
P/N 5034763, and spacer, P/N 350932, as shown.
Place bearing installation tool with lettered side of
bearing facing tool. Use Needle Bearing grease to
hold bearing on tool.
GEARCASE
2
001857
9
213