Bearing And Seal Installation - BRP Johnson J30TEL4SUA 2007 Service Manual

GEARCASE

BEARING AND SEAL INSTALLATION

Driveshaft Bearing Housing Seals
Use an oil seal remover or 2-jaw puller and plate
assembly, P/N 432131, to draw two (2) oil seals
out of the driveshaft bearing housing. Be careful
not to damage driveshaft bearing race.
Remove the O-ring from the housing.
1. O-ring
Driveshaft Bearing
If the driveshaft bearing is pitted, noisy or rough,
press the bearing from the driveshaft and replace
it. Seat new bearing to shaft carefully using press.
To remove driveshaft bearing race in driveshaft
bearing housing, use 2-jaw puller and plate
assembly, P/N 432131.
1
1. Driveshaft bearing
212
BEARING AND SEAL
INSTALLATION
Propeller Shaft Bearing
Apply HPF XR gearcase lubricant to the bearing.
Using bearing installation tool, P/N 5034774, with
lettered side of bearing facing tool, carefully press
bearing into housing. Bearing is properly installed
when tool flange seats against housing.
1
001863
1
1. Bearing installation tool, P/N 5034774
2. Propeller shaft bearing housing
3. Propeller shaft bearing
001865
002513
2
3
002512