BRP Johnson J30TEL4SUA 2007 Service Manual page 213

Propeller Shaft Bearings
Use bearing removal tool, P/N 5034764, to press
bearing from housing.
1
1. Propshaft bearing
2. Reverse gear bearing
Forward Bearing Race
If forward gear bearing is replaced the race must
be replaced. 2-jaw puller, P/N 432129, can be
used with a plate obtained locally, to remove the
bearing race from the gearcase housing.
Pinion Gear Bearing
Put a wood block under the pinion gear bearing.
To remove pinion bearing, assemble removal tool
from Universal Pinion Bearing removal and instal-
lation Kit, P/N 391257, bearing removal/installa-
tion kit, P/N 5000009,
removal/installation tool, P/N 5034763, as shown.
Place removal tool inside the pinion gear bearing.
Drive out the bearing by striking the top of the
shaft with heavy rawhide mallet. Be careful not to
damage the gearcase.
1
2
2
3
4
5
001857
6
1. 1/4 - 20 x 1/2 in. Hex head screw
2. 1 in. O.D. Flat Washer
3. Centering Guide from tool kit 5000009
4. Rod, P/N 326582
5. Pinion gear bearing removal/installation tool,
P/N 5034763
6. 1/4 - 20 x 1 1/4 in. Hex head screw
and bearing
GEARCASE
BEARING AND SEAL REMOVAL
824163
9
211