GEARCASE
BEARING AND SEAL REMOVAL
Shift Rod Disassembly
Remove the stop from the shift rod guide.
1. Shift rod guide stop
Remove the cam pin and separate the shift rod
cam from the shift rod.
Remove the spacer and the magnet from the shift
rod.
Remove the shift rod pin, then remove the guide
and the boot from the shift rod. Remove and dis-
card the O-rings.
1
2
3
4
5
1. Shift rod
2. Boot
3. Shift rod guide
4. Guide O-ring (larger)
5. Shift rod O-ring (smaller)
6. Shift rod pin
7. Magnet
8. Spacer
9. Cam pin
10. Shift rod cam
210
BEARING AND SEAL
REMOVAL
IMPORTANT:
1
while in place. If a bearing is removed for any
reason, it must be replaced.
Propeller Shaft Bearing
Housing Seals
Use an oil seal remover or 2-jaw puller and plate
assembly, P/N 432131 to remove two (2) oil seals
from the propeller shaft bearing housing.
001860
Remove and discard the O-ring.
6
1. O-ring
Reverse Gear Bearing
7
8
Use 2-jaw puller and plate assembly, P/N 432129,
9
to remove reverse gear bearing.
10
001872
Inspect bearings for damage
1
001858