Propeller Shaft Bearing Housing Removal; Propeller Shaft Disassembly - BRP Johnson J30TEL4SUA 2007 Service Manual

GEARCASE
DISASSEMBLY
Propeller Shaft Bearing
Housing Removal
Remove the water pump from the gearcase. Refer
to "WATER PUMP" on page 204.
Remove two (2) bolts that secure the propeller
shaft bearing housing to the gearcase.
1. Bolts (2)
Use a sliding hammer and a propeller shaft
removal to remove the propeller shaft and bearing
housing assembly.
1
1. Sliding hammer, P/N 391008
2. Propeller shaft removal tool, P/N 5034762
3. Propeller shaft
206
3
2

Propeller Shaft Disassembly

IMPORTANT:
during disassembly. Replace all damaged compo-
nents, seals, O-rings, and gaskets upon assem-
bly.
Slide the propeller shaft out of the bearing housing
assembly.
Remove the shim, the reverse gear, and the thrust
washer from the shaft.
2
3
4
1
001829
1. Bearing housing assembly
2. Shim
3. Reverse gear
4. Thrust washer
Pull the push rod out of the end of the propeller
shaft.
Remove the spring from the clutch dog shifter.
3
1
001830
1. Push rod
2. Spring
3. Clutch dog shifter
Clean and inspect all components
1
001842
2
001843