Standard Torque Specifications - BRP Johnson J30TEL4SUA 2007 Service Manual

SERVICE SPECIFICATIONS AND SPECIAL TOOLS

STANDARD TORQUE SPECIFICATIONS

STANDARD TORQUE SPECIFICATIONS
18
Standard Torque Chart
Size In. Lbs.
No. 6 7–10
No. 8 15–22
No. 10 24–36
No. 12 36–48
1/4 in. 60–84
5/16 in. 120–144
3/8 in. 216–240
7/16 in. 336–384
IMPORTANT:
These values apply only when a specific
torque for a specific fastener is not listed in the appropri-
ate section. When tightening two or more screws on the
same part, DO NOT tighten screws completely, one at a
time.
Torque wrench tightening specifications
must be strictly adhered to. Replace any
locking fastener (locknut or patch screw)
if its locking feature becomes weak. Defi-
nite resistance to turning must be felt
when reusing a locking fastener.
If replacement is specified or required
because the locking fastener has become
weak, use only authorized Evinrude/
Johnson Genuine Parts.
Ft. Lbs.
0.58–0.83
1.25–1.83
2–3
3–4
5–7
10–12
18–20
28–32
WARNING
N·m
0.8–1.1
1.7–2.5
2.7–4.0
4.0–5.4
6.7-9.4
13.5–16.2
24.4–27.1
37.9–43.4