Installation - BRP Johnson J30TEL4SUA 2007 Service Manual

Installation

IMPORTANT:
An insulation washer must be
installed between the bonding wire terminal and
the stern bracket.
Attach the bonding wire to the port side stern
bracket. Tighten the screw securely.
Apply Triple-Guard grease to the tilt tube and the
bushings. Insert both bushings into the swivel
bracket.
Install the stern brackets and the tilt tube to the
swivel bracket.
4
1. Swivel bracket
2. Bushings (2)
3. Tilt tube
4. Stern bracket
4
2
1
1. Swivel bracket
2. Bushings (2)
3. Tilt tube
4. Stern bracket
STERN BRACKETS, STEERING ARM, AND SWIVEL BRACKET
Install the tilt tube nut. Leave the nut loose for eas-
ier installation of the PTT unit (or the tilt assist cyl-
inder).
Install the PTT unit (or the tilt assist cylinder)
between the stern brackets. Tighten the tilt tube
nut to a torque of 32 ft. lbs. (43 N·m).
2
1
1. Tilt tube nut
2. PTT unit (or tilt assist cylinder)
2
Install the lower bushing (tapered end first) and
the steering arm seal in the swivel bracket. Make
sure that the lip of the seal is facing outward.
3
After installation, apply Triple-Guard grease to the
seal lip.
001802
4
2
1. Steering arm seal
3
2. Lower bushing
001810
MIDSECTION
1
001811
8
2
1
001797
191