Stern Brackets, Steering Arm, And Swivel Bracket; Removal - BRP Johnson J30TEL4SUA 2007 Service Manual

MIDSECTION

STERN BRACKETS, STEERING ARM, AND SWIVEL BRACKET

IMPORTANT:
An insulation washer must be
installed between the bonding wire terminal and
the exhaust housing.
Attach the bonding wire to the exhaust housing.
Tighten the screw securely.
1. Bonding wire
188
STERN BRACKETS,
STEERING ARM, AND
SWIVEL BRACKET

Removal

Remove the exhaust housing and the oil pan.
Refer to "EXHAUST HOUSING AND OIL PAN" on
page 181.
Remove the screws and the bonding wires from
the stern bracket and the lower mount bracket.
1
1
001762
2
1. Screws
2. Bonding wires
IMPORTANT:
bracket, use sandpaper to tear the black paint off
the lower portion of the pilot shaft for easier
removal.
Before removing the lower mount
1
2
001793