BRP Johnson J30TEL4SUA 2007 Service Manual page 132

POWERHEAD
REMOVAL AND INSTALLATION
Install the cover on the cylinder head. Install and
tighten the bolts to a torque of 89 in. lbs. (10 N·m).
Connect the breather hose to the cylinder head
cover.
3
1
1. Bolts (8)
2. Cylinder head cover
3. Breather hose
IMPORTANT:
After installation, make sure that
the throttle controls are adjusted correctly. Refer
to the FUEL SYSTEM section for the adjustment
procedures.
R C M
EMOTE ONTROL
Install the throttle control rod, the throttle lever, the
throttle control lever, and the bolt.
4
2
1
1. Bolt
2. Throttle control lever
3. Throttle lever
4. Throttle control rod
130
ODELS
Install the throttle control rod, the throttle lever rod,
the throttle drum, and the bolt.
2
3
1. Bolt
2. Throttle drum
3. Throttle lever rod
4. Throttle control rod
001395
T H
ILLER ANDLE
Install the shift lever link.
1. Shift lever link
Install the throttle limiter rod, the throttle lever rod,
the throttle drum, and the bolt.
3
001399
M
ODELS
1
2
4
001398
1
001397