Installation - BRP Johnson J30TEL4SUA 2007 Service Manual

Installation

Before installing the powerhead, remove the oil
pump stop from the oil pan:
•
Remove the bolt.
•
Use a screwdriver to drive the locking edges of
the stop washer upward.
•
Remove the oil pump stop, the stop washer,
and the gasket from the oil pan.
2
3
1
1. Bolt
2. Stop washer
3. Oil pump stop
Install two (2) dowel pins and a new gasket on the
engine holder mating surface.
Install a new O-ring around the driveshaft bore.
Apply Moly Lube to the driveshaft splines.
Lower the powerhead onto the engine holder.
IMPORTANT:
Rotate the crankshaft to aid in
aligning the driveshaft and crankshaft splines.
3
4
2
1. Dowel pins (2)
2. Gasket
3. O-ring
4. Driveshaft
REMOVAL AND INSTALLATION
Apply Gasket Sealing Compound to the threads of
the powerhead mounting bolts. Install and tighten
the bolts to the following specified torques.
Powerhead Mounting Bolt Torques
8 mm bolt
10 mm bolt
1
1. Bolts (6) – starboard side
001417
1
1. Bolts (7) – port side
Install the side cover seal and two (2) pins.
1
2
001418
1. Pins (2)
2. Side cover seal
POWERHEAD
17 ft. lbs. (23 N·m)
37 ft. lbs. (50 N·m)
2
001415
1
1
001416
1
001414
125
7