Typical Page - C - BRP Johnson J30TEL4SUA 2007 Service Manual

INTRODUCTION
TYPICAL PAGE – C
TYPICAL PAGE – C
POWERHEAD
INSTALLATION
IMPORTANT:
screw are serviced as an assembly. Do not disas-
semble.
Denotes necessary
step or information to
prevent damage or
control correct
procedure
Installation
Place mount assemblies in position, with flats fac-
ing away from each other.
Apply Extreme Pressure Grease to all sides of
retainer and install between mounts.
Apply Nut Lock to retainer screw, install the screw,
and torque to 15 to 20 ft. lbs. (20 to 27 N·m).
1. Mount retainer screw
272
10
The motor mount, washer, and
INSTALLATION
V4 M
ODELS
Install base gasket dry. Do not use Permatex
No. 2 or Gasket Sealing Compound .
V6 M
ODELS
Apply Permatex No. 2 gasket sealant to inner
exhaust housing flange. Coat both sides of a new
base gasket with Gasket Sealing Compound .
39820
A M
LL ODELS
Install a new base gasket on adapter. To ensure
proper sealing, mating surfaces must be clean
and free of oil, grease, and foreign matter.
49557
Coat the driveshaft splines with Moly Lube . Do not
apply lubricant to end of driveshaft.
1
49556
Title in italics indicates
a procedure
concerning a
particular model
Title indicates the
procedure specific to
V4 Models is
finished. From this
point, this particular
procedure concerns
V6 Models.
23079
Title indicates
from this point,
All Models
are concerned
23497