THROTTLE CONTROL
Throttle Linkage Adjustments
When replacing a throttle linkage rod or a connec-
tor, refer to the following figures to adjust the
length of the rod to the correct specification.
Make sure that an equal length of rod is threaded
into each connector. Tighten the lock nut against
the connector after adjusting the rod length.
Tiller Handle Models
1
1
1. Throttle lever rod
2. Throttle limiter rod
Rod Length Specifications
Throttle lever rod
Throttle limiter rod
2
2
001632
3.19 in. (81 mm)
9.47 in. (240.5 mm)
Remote Control Models
1
1
1. Throttle lever rod
2. Throttle control rod
3. Shift rod
Rod Length Specifications
Throttle lever rod
Throttle control rod
Shift rod
FUEL SYSTEM
THROTTLE CONTROL
3
2
2
3
001633
3.19 in. (81 mm)
5.51 in. (140 mm)
5.87 in. (149 mm)
109
6