BRP Johnson J30TEL4SUA 2007 Service Manual page 108

FUEL SYSTEM
CARBURETORS
IMPORTANT:
Make sure that the weight of the
float is not applied to the needle valve.
1. Vernier calipers
2. Float height
If the float height is not correct, lightly bend the
adjustment tab to adjust the height of the float. Be
careful not to force the float needle valve into the
seat.
1. Adjustment tab
106
Adjusting the Accelerator Pump Lever Gap
IMPORTANT:
accelerator pump lever is unnecessary. It has
1
been adjusted at factory.
Adjust the gap between the accelerator pump
lever and the pump plunger rod by turning the
adjusting screw.
2
When the throttle valve is fully closed, there
should be no gap.
001630
2
1. Adjusting screw
2. Gap
1
001627
In normal use, adjustment of the
1
001631