Propeller Hardware Installation - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

•
Occasionally, one propeller will not cover a wide
range of boat applications — water skiing to
high speed performance boating. In such cases,
it might be necessary to have a propeller for
each situation.
•
Refer to the Evinrude Genuine Parts and
Accessories Catalog for propeller styles and
sizes.
•
Right-hand propellers are considered standard
rotation propellers. When propelling a boat for-
ward, the propeller rotates in a right-hand
(clockwise) direction as viewed from the rear.
•
Left-hand propellers are considered counter-
rotation propellers. When propelling a boat for-
ward, the propeller rotates in a left-hand (coun-
terclockwise) direction as viewed from the rear.
2
1. Right-hand rotation (clockwise)
2. Left-hand rotation (counterclockwise)
WARNING
For multiple outboard installations always
check to be sure propellers are installed on
the correct engines before aggressively oper-
ating the boat.

Propeller Hardware Installation

WARNING
When servicing the propeller, always shift the
outboard to NEUTRAL position, turn the key
switch OFF and remove the key, so the out-
board cannot be started accidentally.
IMPORTANT:
Evinrude E-TEC G2 outboards
REQUIRE Propeller Hub Kit, P/N 767683, and Nut
& Keeper Assembly, P/N 5008966.
Apply Triple Guard grease to the entire propeller
shaft before installing the propeller.
Install thrust bushing onto propeller shaft with
taper of bushing matching taper of shaft. Then
install the torsion bushing, and bushing and
sleeve into the propeller.
Align splines of propeller and shaft. Push propeller
until seated on the thrust bushing.
Install the spacer over the propeller shaft splines.
Wedge a block of wood between propeller blade
and the anti-ventilation plate. Install the propeller
nut. Tighten to a torque of 70 to 80 ft. lbs. (95 to
109 N·m).
1
Install the keeper, then install a new cotter pin.
009079
Install the anode and screw on the propeller shaft.
Tighten the screw to 177 to 204 in. lbs. (20 to 23
N·m).
1. Thrust bushing
2. Torsion bushing
3. Bushing and sleeve
4. Propeller nut
5. Keeper
6. Cotter pin
7. Anode
8. Screw
Predelivery
Propellers
6
009915
009129
93