Table of Contents
Advertisement
What's New
General Information
Review this installation guide BEFORE beginning
the installation. Pay specific attention to the fol-
lowing sections, as they contain information that is
new, updated or unique to Evinrude E-TEC G2
products:
•
UPDATED: Model Designation on p. 10
•
UPDATED: Outboard Selection on p. 13
•
Reserved Fluid Level Instancing on p. 18
•
UPDATED: Steering Systems on p. 22
•
Battery Cable Requirements on p. 31
•
Accessory Remote Oil Tank on p. 38
•
UPDATED: Multiple Outboard Centerlines on
p. 48
•
Lifting The Outboard on p. 54
•
Mounting Height on p. 55
•
Multiple Outboard Transom Mounting Locations
on p. 56
•
Multiple Outboard Mounting Height on p. 57
•
UPDATED: Plug Installation on p. 58
•
Rigging Hose Installation Options on p. 61
•
NEW: 66° V6 Models Hose and Cable Lengths
(TRAC+ Midsection) on p. 63
•
NEW: 66° V6 Models Hose and Cable Lengths
(Full Featured Midsection) on p. 64
•
74° V6 Models Hose and Cable Lengths (Full Fea-
tured Midsection) on p. 65
•
UPDATED: Cable & Hose Connections on p. 68
•
Multiple Outboard Instancing on p. 72
•
UPDATED: Water Pressure Connection on p. 74
•
Filling and Bleeding the Hydraulic Steering Sys-
tem on p. 76
•
NEW: Biobutanol Blended Fuel on p. 84
•
Fuel System Priming on p. 85
•
Oil Requirements on p. 85
•
Oil Supply Priming on p. 86
•
UPDATED: Steering Position Sensor Calibration
(DPS Models Only) on p. 90
•
Propeller Hardware Installation on p. 93
Steering System Considerations
Counter rotation outboards WITH DPS are now
available. See Model Designation on p. 10.
Improvements have been made to the DPS sys-
tem. Be sure to review Dynamic Power Steering
System Improvements on p. 23.
IMPORTANT:
Install one outboard with DPS for
every non-DPS outboard.
Multiple Outboard Applications
WARNING
Outboards equipped with the DPS-2 system
REQUIRE calibration when multiple out-
boards are installed. Refer to Dynamic Power
Steering System Improvements on p. 23.
Failure to complete DPS system calibration
can cause damage to the tie bar(s) and/or the
transom of the boat due to overloading.
When installing multiple outboards:
•
Each engine requires a separate fuel tank
pickup and fuel hose. See Fuel System
Requirements on p. 36.
•
Each engine requires a separate battery cable.
See Battery Cable Requirements on p. 31.
When installing three or four outboards, the center
outboards should be mounted no more than one
mounting hole location lower or higher than the
outside engines. See Multiple Outboard Mount-
ing Height on p. 57.
IMPORTANT:
Install one outboard with DPS for
every non-DPS outboard.
•
When installing two outboards, one outboard
MUST have DPS.
•
When installing three or four outboards, two
outboards MUST have DPS. See Multiple Out-
board Transom Mounting Locations on p. 56.
•
See Outboard Selection on p. 13.
Also see Hydraulic Steering on p. 144.
Introduction
What's New
7
Advertisement
Chapters
Table of Contents
