BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual page 88

Fuel and Oil
Oil Requirements
Remove the top cover, then the oil fill cap. Fill the
oil tank with outboard lubricant.
1
2
1. Oil fill cap
2. Oil fill
Filling the Accessory Remote Oil
Tank
Remove the oil fill cap. Fill the oil tank with out-
board lubricant.
Oil Capacity
Accessory remote oil tanks are available in the fol-
lowing capacities:
1.8 gallons (6.8 liters)
3.0 gallons (11.3 liters)
10 gallons (37.8 liters)
1
Typical
1. Oil fill cap
Break-In Oiling
NOTICE
The operator must monitor the oil tank level
to confirm oil consumption. This may require
several hours of operation above idle.
86
IMPORTANT:
Evinrude E-TEC models.
The Engine Management Module (EMM) will auto-
matically supply extra oil to the engine for the first
2 hours above 2000 RPM
IMPORTANT:
mark the oil level for reference.
Oil Supply Priming
The oil system of Evinrude E-TEC G2 outboards
is primed at the factory.
009044 Priming the oiling system is only required if:
• The oil tank is run out of oil; or
• The oil system is disassembled for service or
parts replacement.
After refilling an empty oil tank or servicing the oil
system, air MUST be removed from the system
before operating the outboard.
Use Evinrude Diagnostic software v 6.1 or higher
to prime the oil system. See the correct Service
Manual.
The oiling system on these models can also be
primed using the Self-Winterizing feature if diag-
nostics software is not available. See the Opera-
tor's Guide.
009088
DO NOT add oil in the fuel tank on
Make sure the oil tank is full and