BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual page 73

Hose and Cable Clips
74° V6 Models ONLY
After completing connections, re-position the two
clips, P/N 352531, from the fuel and oil supply
hoses as shown:
•
Attach one clip to the fuel hose and oil supply
hose.
•
Attach the second clip to the oil supply hose
and positive battery cable.
Make sure the crimp of each Oetiker clamp is
positioned forward and cannot cut into or chafe
any other cable or hose.
4
3
2
1
1. Clips
2. Fuel hose
3. Oil supply hose
4. Positive battery cable
ALL Models
Make sure there is loose slack in all hoses and
cables.
•
If port cable entry is used, slack should be to the
starboard side of the cable entryway.
Buss Cable, Hoses, and Wire Routing and Connections
1
009168
•
If starboard cable entry is used, slack should be
to the port side of the cable entryway (shown
below).
1. Slack
Hoses and cables should NOT bind or be pulled
taught when engine is in a full turn.
Install cover on cable entryway with four screws.
Make sure cables are not pinched between cable
entryway cover and housing.
1
1. Cables NOT pinched
Outboard Rigging
1
009169
009170
71
4