BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual page 69

Tighten both hydraulic hose fittings to a torque of
15 ft. lbs (20.3 N·m).
1
1. Hydraulic fitting (port side shown)
Hydraulic Hose Routing
(TRAC+ Midsection)
Outboards with the TRAC+ midsection may use
an external hydraulic steering cylinder. Install the
steering cylinder on the outboard first.
IMPORTANT:
Refer to the installation instruc-
tions provided with the steering cylinder.
There are multiple options for routing hydraulic
hoses. The following are some suggested options.
1. In applications using bulkhead fittings, route the
hydraulic steering hoses outside of the flexible
conduit, directly to the steering cylinder.
1
1. Bulkhead fittings
2. In applications where the hydraulic hoses are
routed with other rigging, the hydraulic hoses MAY
be routed through the flexible conduit.
Route the hoses into the rigging center and out
the opposite side as shown.
Buss Cable, Hoses, and Wire Routing and Connections
IMPORTANT:
hose to the rigging center.
1. Turn the outboard in the opposite direction of
hose entry.
2. Inspect hydraulic hoses for clearance to pre-
vent the hoses from kinking during a full turn.
3. Make sure the steering cylinder does NOT con-
tact the rigging hose.
Adjust hose lengths as needed to prevent kinks.
009109
3
Starboard Entry Shown
1. Outboard turned OPPOSITE hose entry
2. Inspect hydraulic hoses NOT kinked
3. Inspect steering cylinder NOT contacting rigging hose
Hydraulic Hose Connections
Refer to the installation instructions provided with
the steering cylinder for correct hose installation.
Install the Hose Retainer, P/N 359711, over the
hoses and thread into the rigging center.
1. Hose retainer
F02
Remove the rigging hose from the rigging center
to continue with hose and cable installation.
Outboard Rigging
Temporarily connect the rigging
1
4
1
2
009913-1
009914
67