Hydraulic Steering Hoses - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Outboard Rigging
Buss Cable, Hoses, and Wire Routing and Connections

Hydraulic Steering Hoses

WARNING
Incorrect connection of hydraulic hoses will
cause the engine to steer in the opposite
direction of the helm input.
This can result in loss of boat control and
injury to the occupants.
Hydraulic Hose Routing
Full Featured Midsection
First install the hydraulic steering hoses through
the flexible conduit.
NOTICE
Install steering hose
P/N 357893 from the owners kit to prevent
hydraulic hose damage.
Next, install steering hose anti-kink retainer onto
the:
•
PORT hydraulic hose IF the port cable entry is
used.
•
STARBOARD hydraulic hose IF the starboard
cable entry is used (shown).
IMPORTANT:
Make sure the steering hose anti-
kink retainer is installed on the hydraulic hose as
shown:
•
anti-kink retainer should touch the strain relief
on the hydraulic hose.
•
anti-kink retainer should be positioned to pre-
vent the hydraulic hose from chafing against the
rigging center.
1. Anti-kink retainer
66
anti-kink retainer,
1
009108
Then route the hydraulic steering hoses through
the rigging center as shown. Take care NOT to
kink the hoses during installation.
Hydraulic Hose Connections
Connect the PORT hydraulic hose from the helm
to the PORT hydraulic steering fitting on the stern
bracket. Tighten the nut by hand until fittings are
seated.
Connect the STARBOARD hydraulic hose from
the helm to the hydraulic steering fitting on the
STARBOARD stern bracket. Tighten the nut by
hand until fittings are seated.
PORT Hydraulic
Hose
PORT Hydraulic
Steering Fitting
STARBOARD
Hydraulic Hose
STARBOARD Hydraulic
Steering Fitting
009086