Safety Information - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Introduction

Safety Information

Safety Information
This publication is written for qualified, factory-
trained technicians who are already familiar with
the use of Evinrude Special Tools. The included
information is not a substitute for work experience.
It is an organized guide for reference, repair, and/
or maintenance.
The following symbols and/or signal words
may be used in this document:
DANGER
Indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not
avoided, could result in death or serious
injury
CAUTION
Indicates a hazardous situation which, if not
avoided, could result in minor or moderate
personal injury.
NOTICE
Indicates an instruction which, if not fol-
lowed, could severely damage engine compo-
nents or other property.
These safety alert signal words mean:
ATTENTION!
BECOME ALERT!
YOUR SAFETY IS INVOLVED!
IMPORTANT:
Identifies information that controls
correct assembly and operation of the product.
ENVIRONMENTAL NOTE:
A note which provides tips and behaviors related
to protecting the environment.
4
DO NOT perform any work until you have read
and understood these instructions completely.
Torque wrench tightening specifications must
strictly be adhered to.
Should removal of any locking fastener (lock tabs,
locknuts, or patch screws) be required, always
replace with a new one.
When replacement parts are required, use Evin-
rude Genuine Parts or parts with equivalent char-
acteristics, including type, strength and material.
Use of substandard parts could result in injury or
product malfunction.
Always wear EYE PROTECTION AND APPRO-
PRIATE GLOVES when using power tools.
Unless otherwise specified, engine must be OFF
when performing this work.
Always be aware of parts that can move, such as
flywheels, propellers, etc.
Some components may be HOT. Always wait for
engine to cool down before performing work.
If you use procedures or service tools that are not
recommended in this manual, YOU ALONE must
decide if your actions might injure people or dam-
age the outboard.
This document may be translated into other lan-
guages. In the event of any discrepancy, the
English version shall prevail.