Buss Cables; Battery Cables; Fuel Hose; Oil Supply Hose - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Boat Rigging
Cable and Hose Installation
2
1
Typical Outboard Installation
1. Remote oil tank (optional)
2. Anti-siphon valve
3. Starting battery
4. Accessory battery
5. Water separating fuel filter
6. Rigging Tube
2
1
Typical Engine Bracket Installation
1. Remote oil tank (optional)
2. Anti-siphon valve
3. Starting battery
4. Accessory battery
5. Water separating fuel filter
6. Rigging Tube
40
3 4
+ - + -
5
6
009092
3
4
- -
+ +
5
6
009093

Buss Cables

Route buss cables from the boat through a rigging
hose into the rigging center. Refer to Rigging
Center Connections,74° V6 Models on p. 70.

Battery Cables

Route cables from the boat through a rigging hose
into the rigging center. Refer to Rigging Center
Connections,74° V6 Models on p. 70.

Fuel Hose

Route the fuel hose from the boat through a rig-
ging hose into the rigging center. 74° V6 models
do not require a primer bulb.
Refer to Rigging Center Connections,74° V6
Models on p. 70.

Oil Supply Hose

If installing an optional remote oil tank, route the
oil supply hose from the boat through a rigging
hose into the rigging center.
Refer to Rigging Center Connections,74° V6
Models on p. 70.
1
1. Fuel supply hose and fuel fitting - 3/8 in. (9 mm)
2. Oil supply hose and fitting - 1/4 in. (6 mm)

Rigging Hose

Make sure all cables, wiring, and hoses have
been identified and fitted to the appropriate
lengths. Refer to Outboard Rigging on p. 59.
2
003963