Fuel Flow Requirements - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Fuel Filter Kit, P/N 174176, meets all require-
ments for a water-separating fuel filter.
2
1
Typical Fuel Supply Configuration
1. Water separating fuel filter
2. Anti-siphon valve, in fuel pick-up of tank

Fuel Flow Requirements

Fuel tank pickup
tube; minimum ID
Fuel fittings;
minimum ID
Fuel supply hoses;
minimum ID
Fuel tank pickup
screen
174176
Antisiphon valve
Remote fuel filter
Maximum fuel pump
lift height
009087
Boat Rigging
Fuel System Requirements
150 – 300 HP
3/8 in. (9.5 mm)
9/32 in. (7.1 mm)
3/8 in. (9.5 mm)
100 mesh, 304 grade
stainless steel wire,
0.0045 inch (0.1143 mm)
wire diameter, 1 inch (25
mm) long
2.5 in. (63.5 mm) Hg maxi-
mum pressure drop at 20
gph (76 l/hr) flow
0.4 in. Hg maximum pres-
sure drop at 20 gph (76
l/hr) flow,
150 in. 2 (1290 cm 2 ) of filter
area
Fuel pump should not be
located more than 30 in.
(76.2 cm) above bottom of
fuel tank
1
2
37