BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual page 31

of clearance between the handle and any part of
the boat throughout the control lever travel.
85.5°
2.5 in (64 mm)
Use an appropriate drill template to cut mounting
holes. Templates are included with the remote
control installation instructions.
1. Template
Install control with hardware provided.
IMPORTANT:
Make sure remote control assem-
bly is secure and does not move during operation.
NOTICE
Do not connect boat accessories to the key
switch of an ICON II system. Connecting
accessories to the key switch can cause low
current, resulting in erratic operation of the
remote control system.
FWD
NEUTRAL
15.0°
15.0°
REV
40.5°
007920
1
007922
When installing an electronic shift and throttle net-
work, remember:
•
Use the Accessory Power Connector provided
on the digital control harness – do NOT use the
key switch to power accessories (switched B+).
•
Accessories connected to the accessory power
connector should not exceed 5 amps.
•
Use Y-Harness, P/N 587230, in applications
requiring multiple accessories.
Y-Harness, P/N 587230
Boat Rigging
Remote Controls
1
2
587230
29