Helm Compatibility; Dynamic Power Steering System Improvements - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Table of Contents

Advertisement

Hydraulic Steering Fluid
Refer to Filling and Bleeding the Hydraulic
Steering System on p. 76, for hydraulic fluid rec-
ommendations.
DPS Helm Compatibility
NOTICE
Use ONLY the helms listed in the Recom-
mended Helm Charts on p. 25, when installing
Evinrude E-TEC G2 outboards.
Pro Series Helms
"Pro Series" helms are designed for use on
high-performance boats capable of speeds in
excess of 65 mph (105 kph) with a single,
non-power assisted outboard up to 300 HP.
IMPORTANT:
NEVER use Ultraflex SVS or
SeaStar Pro Series helms in multiple outboard in-
stallations.
Other Helms
Helms provided by other manufacturers (for
example Mercury Marine Verado) are NOT com-
patible with the hydraulic steering system of Evin-
rude E-TEC G2 outboards.
Dynamic Power Steering System
Improvements
Improvements have been made to the DPS sys-
tem to support the Evinrude i-Dock steering sys-
tem, Pro Series helms and three or four outboard
installations.
Improvements (DPS-2) are effective beginning
with:
74° V6 – AFA models
66° V6 – AAA models
IMPORTANT:
Improvements also effect helm
and outboard selection. Carefully review the fol-
lowing information:
DPS System Compatibility
AB 200 H.O. – 300 HP, 74° V6 ONLY
The DPS-1 system used on ABA model outboards
is NOT compatible with the DPS-2 system used
on 74° V6, AFA and newer model outboards.
Do
NOT
install
ABA
DPS-equipped outboards on the same transom.
NOTICE
Do NOT use Pro Series helms with a
DPS-equipped ABA model Evinrude E-TEC
G2 outboard.
Use of these helms with DPS-equipped ABA
model will result in damage to the DPS power
steering pump.
Pro-Series helms MAY be used in the following
single engine, IHS Evinrude E-TEC 74° V6 ABA
outboard models:
E200LHOABA
E225LHOABA
E250LHOABA
AA & Newer 66° V6 and
AF & Newer 74° V6
Ultraflex SVS or SeaStar Pro Series helms may
be used in single engine installations of the above
model Evinrude E-TEC G2 outboards.
IMPORTANT:
Multiple
REQUIRE:
correct outboard alignment
steering position sensor calibration.
Refer to Multiple Outboard Installations on
p. 89.
Boat Rigging
Steering Systems
and
AFA
model
outboard
installations
23
1
2

Advertisement

Table of Contents
loading

Table of Contents