BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual page 20

Networks
Remote Control Networks
When installing a NMEA 2000 digital network,
remember:
•
A terminator must be installed at each end of
the network. A terminator kit provides the
required pieces.
•
There should be no open or unused network
device connectors.
•
The network should be grounded at a single
location only.
Refer to NMEA 2000 Network on p. 20.
Refer to Digital Displays on p. 132.
Reserved Fluid Level Instancing
When installing and setting up fluid level devices
on the NMEA 2000 network, the following
instance numbers are reserved and should not be
used for any other devices.
Instance Oil Fuel Other Reserved For:
0 X
1 X
2 X
3 X
4 X
1
5 X
1
6 X
1
7 X
1
8 X
9 X
10 X
11 - 15
1. ICON II remote controls: Default settings shown. Can be
reconfigured to monitor fuel or oil levels.
2. ICON Touch digital displays: Default settings shown. Can
be reconfigured to monitor fresh water, gray water, or black
water levels.
18
On-Engine Oil Tank
(up to 4 Engines)
ICON II
1
Remote Controls
2
ICON Touch
2
2
Digital Displays
2
Navico Devices
SystemCheck and Analog Gauges
SystemCheck gauges may be used with elec-
tronic shift and throttle or mechanical remote con-
trol systems.
If an analog gauge display is used, the NMEA
2000 network transmits monitored information to
an accessory digital to analog converter, which in
turn supplies the information to SystemCheck and
other analog gauges.
A SystemCheck 2 inch gauge or tachometer is
REQUIRED.
Refer to Analog Displays on p. 140