03 Single Binnacle Mount Remote Control / Second Station - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Diagrams
Digital Remote Controls

03 Single Binnacle Mount Remote Control / Second Station

Ref Description
1 START – STOP Switch
2 Single Binacle Mount Remote Control
3 *Remote Control Harness
4 START – STOP Switch Connection
5 Remote Control to NMEA 2000 Network Connection
6 Accessory Power Out (12 VDC)
7 Remote Control Network Connection
8 Network Power In (12 VDC)
9 Oil Level 1 & 2 (not used on second station)
10 Fuel Level 1 & 2 (not used on second station)
11 Trim Switch Connection
12 Terminator Kit
13 Connection to NMEA 2000 Digital Display
14 Connection to NMEA 2000 Network
15 NMEA 2000 Buss Cables
2 ft. (0.6 m)
6 ft. (1.8 m)
15 ft. (4.5 m)
25 ft. (7.6 m)
16 Backbone Buss Cables
15 ft. (4.5 m)
20 ft. (6.0 m)
25 ft. (7.6m)
17 Backbone Buss Cable Extensions
1 ft. (0.3 m)
2 ft. (0.6 m)
4 ft. (1.5 m)
10 ft. (3.0 m)
15 ft. (4.5 m)
20 ft. (6.0 m)
25 ft. (7.6 m)
18 6–Port Hub
19 Network Power Cable, 15 ft. (4.5 m)
19 Network Power Cable, 25 ft. (7.6 m)
NS Network Power Cable Extension, 5 ft. (1.5 m)
NS Network Power Cable Extension, 10 ft. (3.0 m)
20 Fuel Tank Sender
21 Connection to NMEA 2000 Accessories
* "Y" Harness (Optional accessory)
118
P/N Notes
766555
766563
– Included with Remote Control
–
–
–
–
–
–
–
–
764155
–
–
–
765132
764161
764162
764163
–
587173
587174
587175
–
587176
587177
587178
587179
587180
587181
587182
587172 See IMPORTANT note below
587184 10 Amp fuse
587183 10 Amp fuse
587185
587186
–
– GPS, Triducer, etc.
Use to power digital displays & accessories to be
587230
powered when the key switch is ON.