Owner's Responsibility; Epa Emission Regulations - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Table of Contents

Owner's Responsibility

The owner/operator is required to have outboard maintenance performed to maintain emission levels

within prescribed certification standards.

The owner/operator is not to, and should not allow anyone to, modify the outboard in any manner that

would alter the horsepower or allow emissions levels to exceed their predetermined factory specifica-

tions.

Tampering with the fuel system to change horsepower or modify emission levels beyond factory settings

or specifications will void the product warranty.

All new 1999 and more recent Evinrude outboards are certified to the EPA as conforming to the require-

ments of the regulations for the control of air pollution from new watercraft marine spark ignition out-

boards. This certification is contingent on certain adjustments being set to factory standards. For this

reason, the factory procedure for servicing the product must be strictly followed and, whenever practical,

returned to the original intent of the design. The responsibilities listed above are general and in no way a

complete listing of the rules and regulations pertaining to the EPA requirements on exhaust emissions

for marine products. For more detailed information on this subject, you may contact the following loca-

tions:

U.S. Environmental Protection Agency

Office of Transportation and Air Quality

Certification Division

Gasoline Engine Compliance Center

2000 Traverwood Drive

Ann Arbor, MI 48105

EPA Internet Web Site:

www.epa.gov/otaq

Emissions-Related Installation Instructions

Introduction

Table of Contents

Table of Contents