Dynamic Power Steering (Dps) - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Predelivery
Water Test and Final Adjustments
During operation, the outboard will automatically
trim up or down to an acceptable trim angle based
on pre-programmed parameters.
Use the trim/tilt switch on the control lever to fine
tune to an optimum trim angle.
IMPORTANT:
Use of the trim/tilt switch to manu-
ally adjust the outboard trim angle will temporarily
deactivate i-Trim.
To reactivate i-Trim:
•
use the trim/tilt switch to trim the engine to the
full down position
•
bring the engine to idle speed.

Dynamic Power Steering (DPS)

Evinrude E-TEC G2 models equipped with
Dynamic Power Steering (DPS), offer three power
steering assist levels.
Power Steering Assist Levels
All power steering assist levels provide the same
rate of assist at engine speeds below 4500 RPM.
As engine speed increases above 4500 RPM,
assist levels progressively decrease.
WARNING
Selection of power steering assist level is
operator preference.
Be aware that changing the power steering
assist level can affect boat handling.
After changing the level of power steering
assist, operate the boat with care to become
familiar with any changes in boat handling
characteristics.
The factory default assist level is "Minimum". Use
the Evinrude ICON-Touch or ICON CS digital dis-
play to change the power steering assist level.
Refer to the Evinrude ICON-Touch or ICON CS
user's guide.
100
If the boat is not equipped with an ICON digital
display, use Evinrude Diagnostic software v 6.1 or
higher to change the power steering assist level.
1
1. DPS Assist 009143