SolarEdge StorEdge Solution with Backup Installation Manual page 66

DIP Switch Setup in the StorEdge Connection Unit
Verify that the DIP switches on the StorEdge Connection Unit are set as described in the
following table, according to the components used in the system (see Figure 28 ):
In StorEdge Connection Unit with two DIP switches:
Hardware configuration
Auto-transformer with connected over-
temperature sensor
No auto-transformer, or auto-transformer with
over-temperature sensor not connected
No external emergency stop button
External stop button (if installed, must be
normally-closed)
In StorEdge Connection Unit with three DIP switches:
Hardware configuration
Auto-transformer with
connected over-
temperature sensor
No auto-transformer, or
auto-transformer with
over-temperature sensor
not connected
No external stop button
External stop button (if
installed, must be
normally-closed)
StorEdge Solution with Backup MAN-01-00262-1.5
Chapter 7: StorEdge Inverter Connections
DIP switch 1
(leftmost) setup
ON ( up ) -
default
ON ( up ) -
default
ON ( up ) -
default
OFF (down)
Left DIP switch Right DIP switch
(SW1) setup
ON ( up ) -
default
ON ( up ) -
default
ON ( up ) -
default
OFF (down)
DIP switch 2
(middle) setup (rightmost) setup
ON ( up ) - OFF (down) -
default
ON ( up ) -
default
ON (up)
OFF (down)
65
(SW2) setup
OFF (down) -
default
ON ( up )
DIP switch 3
default
ON ( up )