Installation Equipment List; Inverter Transport And Storage - SolarEdge StorEdge Solution with Backup Installation Manual

Installation Equipment List

Standard tools can be used during the installation of the SolarEdge system. The
following is a recommendation of the equipment needed for installation:
Standard flat-head screwdrivers set
Non-contact voltage detector
Cordless drill (with a torque clutch) or screwdriver and bits suitable for the surface
on which the inverter and optimizers will be installed and for opening the StorEdge
Connection Unit drill guides. Use of an impact driver is not allowed.
Appropriate mounting hardware (for example: stainless bolts, nuts, and washers)
for attaching:
the mounting brackets to the mounting surface
the power optimizer to the racking (not required for smart modules)
Wire cutters
Wire strippers
Voltmeter
For installing the communication options, you may also need the following:
For Ethernet:
CAT5/6 twisted pair Ethernet cable with RJ45 connector.
If using a CAT5/6 cable spool: RJ45 plug and RJ45 crimper
For RS485:
Four- or six-wire shielded twisted pair cable.
Watchmaker precision screwdriver set

Inverter Transport and Storage

Transport the inverter in its original packaging, facing up and without exposing it to
unnecessary shocks. If the original package is no longer available, use a similar box that
can withstand the weight of the inverter (refer to the inverter weight in the specification
datasheet provided with the unit), has a handle system and can be closed fully.
Store the inverter in a dry place where ambient temperatures are -13°F to 140°F /
-25°C to +60°C.
StorEdge Solution with Backup MAN-01-00262-1.5
Chapter 1: Overview 19