Storedge Connection Unit Leds - SolarEdge StorEdge Solution with Backup Installation Manual

StorEdge Connection Unit LEDs

There are three LEDs on the lower board of the StorEdge Connection Unit, near the DIP
switches:
In normal operation, the middle and bottom LEDs indicate auxiliary voltages (13V
from DC/DC, 5V and 3.3V) and should always be lit.
The top LED should be lit when the inverter DC voltage is at least 200 Vdc (check
when both inverter ON/OFF switch and StorEdge Connection Unit switch are ON).
You can check the status screen for the Vdc value.
If all LEDs are OFF:
Check that AC voltage exists in the inverter
Check that the communication cable between the StorEdge Connection Unit
and the digital board is properly connected.
If the top LED is ON, and middle and bottom LEDs are off - an internal failure has
occurred. Contact SolarEdge support.
StorEdge Solution with Backup MAN-01-00262-1.5
Figure 44: StorEdge Connection Unit LEDs
Appendix A: Troubleshooting 127