SolarEdge StorEdge Solution with Backup Installation Manual page 121

120 Verifying StorEdge Components Functionality
S e l f - t e s t c o m p l e t e d
s u c c e s s f u l l y
A n y b u t t o n t o c o n t .
If an error message is displayed during the test, use the following table to resolve
the error.
Error
Bat 1 charge failed
Bat 1 discharge failed
Low SOE
Battery comm. error
Turn switch to On
To test the meter and inverter:
1. Verify that AC is ON.
2. Check the meter (installed in export or consumption position, CT arrows point to
the grid):
a. Turn the inverter ON/OFF switch to OFF.
b. Connect loads on one of the measured phases.
c. Press the external LCD light button to display the Import or Consumption meter
status screen, and check that the import or consumption energy (Energy[Wh]) is
greater than 0 (may take a few minutes, depending on the loads size):
I m p o r t M e t e r
S t a t u s : < O K / E r r o r # >
P o w e r [ W ] : x x x x x . x
E n e r g y [ W h ] : X X X X X . X
d. Press the LCD light button to display the Export meter status screen, and check
that the Export power is equal to zero. If it is not zero, check the CT direction on
all connected phases.
3. Turn the inverter ON/OFF switch to ON.
4. Turn the StorEdge Connection Unit switch to ON.
5. While the modules are exposed to sunlight (PV system is connected to the grid and
the inverter is producing power), press the inverter LCD light button to display the
power status screen, and check that the grid AC output (Vac) increases to 220-240V,
Check that the power and communication cables
between the battery and inverter are properly connected.
Check that the power and communication cables
between the battery and inverter are properly connected.
Charge the battery to 20 percent SOE at least.
Check that the communication cables between the
battery and inverter are properly connected.
Turn the inverter ON/OFF switch to ON.
StorEdge Solution with Backup MAN-01-00262-1.5
Solution