Extender/Bridge Mode - ZuniDigital ZuniConnect ZR301 User Manual

WIRELESS EXTENDER / WIRELESS BRIDGE MODE
Wireless Bridge / Extender Information
In this mode, the ZR301 can connect to an existing wireless network and then convert the wireless network signal into a
signal that can be sent over wire (CAT-5). This unit also acts as a wireless extender to extend the range of an existing
wireless router's signal to reach areas that are not covered by the existing router.
For best performance, we recommend setting up the ZuniConnectZR301 close to where you intend to use it. For the best
results do not place the ZuniDigital ZR301 near any large metal objects or magnets (like those found in speakers). Also
note that elevating the ZR301 from the floor will increase wireless broadcast signal performance and range.
ONCE YOU SELECT EXTENDER/BRIDGE MODE
FROM THE SETUP HOMEPAGE
Step 1 – Attach Ethernet Cable
Attach one side on an RJ-45 Ethernet cable into the LAN (Ethernet) port of the ZR301, and then connect the other end to
the Ethernet port on your computer.
Page | 9