SolarEdge SEHAZB-SWITCH-MTR Quick Installation Manual

AC Switch with Meter Quick Installation Guide
Overview
The SolarEdge Smart Energy Management solutions allow increasing the self-consumption of a site. One method used for this purpose is controlling the usage
(consumption) of loads using Device Control products.
The SolarEdge Device Control units divert power to an appliance (load) according to pre-configured schedules.
You can configure the devices locally through the SolarEdge inverter or remotely, via the SolarEdge monitoring portal.
The SolarEdge AC Switch with meter (referred to as "the device") is a ZigBee wireless AC switch with a built-in energy and power-consumption meter that
provides power measurements up to 2.5kW. Based on these measurements and on the system configuration it switches the loads on and off.
To enable the AC Switch functionality, the following supporting devices must be installed:
Device Control ZigBee Module, installed inside the inverter. For physical installation refer to
l
control-zigbee-module-installation-guide.pdf.
SolarEdge Modbus Meter. Refer to
l
Installation
CAUTION!
This product must be operated under the specified operating specifications, as described in the latest technical specification datasheet.
l
Configure the product so that the load connected is not switched on or off more frequently than specified by the load manufacturer.
l
Do not connect loads that require a continuous current supply (e.g. fridge, freezer).
l
Do not use the product if it is damaged or malfunctioning.
l
Never connect loads that can cause injuries or fire if they are switched on unintentionally (e.g. an iron).
l
Do not let the product come into contact with water or other liquids.
l
The enclosed documentation is an integral part of this product. Keep the documentation in a convenient place for future reference and observe
l
all instructions contained therein.
1. Release the two screws of the device front cover and remove the cover.
2. Position the device against the wall and mark the drilling hole locations, at a maximum distance of 50 m from the inverter. Do not use the device as a drilling
template as it may damage the enclosure.
AC Switch Quick Installation Guide MAN-01-00288-1.1
Scan for a more detailed Installation Guide.
Figure 1: SolarEdge System with Device Control
http://www.solaredge.com/files/pdfs/solaredge-meter-installation-guide.pdf
http://www.solaredge.com/sites/default/files/se-device-
1