Verifications For A New Assembly - Record DFA127 Instructions Manual

22

Verifications for a new assembly

The following points must be checked:
Base fixing
Chassis
Door hinge
Door leaf
Arm
Function
Electric supply
Wiring
Control unit connection Was the prescribed cable used and has it been installed correctly?
Configuration
Calibration run
Control unit
Actuating devices
Safety elements
Safety functions
Electrical door lock
Casing
Logo
102-127108955
Verifications for a new assembly
Is the DFA 127 securely fixed to the backing construction?
Is the attachment still ok?
Can the door leaf be moved smoothly?
Do the leaf weight and the leaf width correspond to the defaults in accor-
dance with the diagram in this manual?
Has the fixing screw of the arm been firmly tightened?
Does the movement of the door give reason for dissatisfaction?
Is the outer sheathing of the supply cable intact up to the mains adaptor
cover?
Are all cables connected and have the clamping screws been firmly tight-
ened? Are all the connection assemblies to the motor in order?
Was the operator configured in accordance to the default?
Was the configuration sheet filled out and placed under the operator's cas-
ing?
Has a calibration run been completed?
Functional check of all operation modes
Adjustment and functional test of motion sensors, push button, pull-switch,
etc.
Adjustment and functional test of safety cells on door leaves
(SIO / SIS)
Check external connections (EMERGENCY STOP / SSK).
Does the electrical door lock have enough free motion?
Is the diode fitted over the door lock connection?
Functional test of the electrical door lock and the monitoring
Have the casing and the side cover been installed properly?
Is the record logo correctly attached?
V1.1
22
93/ 102