Operating Instructions Dfa 127; Controls Of The Stg 127 - Record DFA127 Instructions Manual

14

Operating instructions DFA 127

14.1

Controls of the STG 127

General
The STG 127 operates with an active HIGH level, i.e. a +24 V level must be applied to acti-
vate a function. Safety inputs are activated during interruptions.
The signal ground (0V) is connected to the protective earth.
Jumpers
J13:
J14:
LED's
LD1:
LD2:
LD3:
Key (S1)
This is a multifunctional key (MF).
The selection of the function is carried out by the control LED according to the following ta-
ble.
Release key while:
1. light pulse on LD1
2. light pulse on LD1
3. light pulse on LD1
4. light pulse on LD1
5. light pulse on LD1
6. light pulse on LD1 *
7. light pulse on LD1
8. light pulse on LD1
9. light pulse on LD1 **
Press key for approx. 13 seconds
102-127108955
CAN-line termination
Master / Slave
Jumper at position M1 for Master (factory settings)
Jumper at position S1 for Slave CAN-line termination
(red) Control LED for push-button operation (S1)
(green) +35V
Off during power failure
(green) +24V
Lights up if +24V is present.
Caution: in the event of a power failure a processor reset takes place 1 second
after this LED goes off.
Operating instructions DFA 127
Function:
AKI
Learn door parameters
Configuration mode on (technician's level)
* Learn spring type
Default parameter loading of door type (TT)
** Factory setting of programming and configura-
tion
Hardware-Reset (new start of control)
V1.1
14
54/ 102