Advertisement
Quick Links
Network Interface Board GX4
For Machine Code: J012, J013
(Code:J510-17)
INSTALLATION GUIDE
This manual describes how to use the
GX 3000S and GX 3000SF models. (Il-
lustrations are based on the GX
3000SF model.)
Important
❒ Be sure to unplug the machine be-
fore installing or removing the net-
work interface board.
❒ Do not subject the network inter-
face board to impact or other phys-
ical stress.
1.
Ethernet cable connector
A
B
C
AQQ149S
D
Check that the power cord of the
machine is not plugged in.
Lift the connector cover.
Check the network interface board's
orientation, and then install the
network interface board gently.
Close the connector cover.
AQQ137S
AQR223S
1
Advertisement
Related Manuals for Ricoh GX4
Summary of Contents for Ricoh GX4
- Page 1 Network Interface Board GX4 For Machine Code: J012, J013 (Code:J510-17) INSTALLATION GUIDE This manual describes how to use the Check that the power cord of the GX 3000S and GX 3000SF models. (Il- machine is not plugged in. lustrations are based on the GX 3000SF model.)
- Page 2 Note ❒ Be sure to push the network in- terface board fully into the ma- chine. ❒ To check whether the network interface board has been in- stalled correctly, press the Menu key and check the menu. If the network interface board has been installed correctly, “Network Settings”...