Parameters For Filling In The Package Fiche - Immergas MAGIS PRO ERP Instruction And Recommendation Booklet

3.18 PARAMETERS FOR FILLING IN
THE PACKAGE FICHE.
Should you wish to install an assembly starting
from the Magis Pro ErP package, use the package
fiche shown in Fig. 3-11.
To fill it in correctly, enter the figures shown in
tables Fig. 3-9 and 3-10 (as shown in the package
fiche facsimile Fig. 3-8).
The remaining values must be obtained from
Facsimile for filling in the package fiche for preferential boiler space heaters.
Room central heating seasonal energy efficiency of the heat pump
Temperature control
From temperature
control board
Supplementary boiler
From boiler board
Solar contribution
From the board of the solar device
Dimensions of the
manifold (in m
( 'III' x
Room central heating seasonal energy efficiency of the assemble in av-
erage climate conditions
Room central heating seasonal energy efficiency class of the assemble in average
climate conditions
Room central heating seasonal energy efficiency in colder and hotter climate conditions
Colder:
The energy efficiency of the set of products indicated in this sheet may not reflect the actual
energy efficiency after installation since such efficiency is affected by additional factors, such as
the heat loss in the distribution system and the size of the products compared to the size and
features of the building.
the technical data sheets of the products used to
make up the assembly (e.g. solar devices, integra-
tion boiler, temperature controllers).
Use sheet fig. 3-11 for "assemblies" related to
the central heating function (e.g.: heat pump +
temperature controller).
N.B.: since the product is standard supplied with
a temperature controller, the package fiche must
always be completed.
Class I = 1 %, Class II = 2 %,
Class III = 1.5 %, Class IV = 2 %,
Class V = 3 %, Class VI = 4 %,
Class VII = 3.5 %, Class VIII = 5 %
Seasonal central heating energy efficiency of the room
(
Efficiency of the
Volume of the
manifold (in %)
) tank (in m )
2 3
+ 'IV' x ) x 0.45 x (
G F E D
< 30 % ≥ 30 % ≥ 34 % ≥ 36 % ≥ 75 % ≥ 82 % ≥ 90 % ≥ 98 % ≥ 125 %≥ 150 %
5
%
- 'V' =
(%)
- 'I' ) x "II" =
Classification of the
tank
A* = 0.95, A = 0.91,
B = 0.86, C = 0.83,
D-G = 0.81
/ 100) x
C B A A A
+ ++
5
Hotter: + 'VI' =
53 53
1
%
'I'
2
+
%
3
- %
4
+
%
=
5
%
A
+++
%
Fig. 3-8